Also I found a laptop and installed the Ubuntu 14. Note: Try to set a system restore point before installing a device driver. Being an easy-to-use utility, The Drivers Update Tool is a great alternative to manual installation, which has been recognized by many computer experts and computer magazines. I followed Debian instructions for. Following these instructions to specify the driver you want to build and install by running the following command: sudo make defconfig-ath9k Now, run make again: sudo make This time you should receive no errors. Thanks for answering, I'll mark your answer as accepted. First, clean the build area by typing this command: sudo make clean Then, use this command to build and compile: sudo make You should receive an error and some instructions.
When you sign back in, open a terminal. Follow these steps: 1 Go to the official. It also didn't show up on the list of network interfaces. What can I do at this point to troubleshoot the installation? You can connect your computer with a wired network, or you can download the driver on another computer with Internet. When it is done, install the driver with the following command: sudo make install You will see some messages saying something about a key.
. I put some thorough explanation in that link is for embedded board but the same principle apply for any Wheezy system. This may take some time to finish. As I am developing a WiFi product, I want to capture the WiFi traffic wirelessly with Wireshark. Then I downloaded the backports 3.
I did the following to get it working on my system, also Wheezy. The tool contains only the latest versions of drivers provided by official manufacturers. The information on this page is for informational purposes only. Then I noticed that I need a driver for this adaptor. It might not be needed but these are kernel modules so that's what we will do by running the following command: sudo update-initramfs -k all -u and don't forget to update grub when you are done: sudo update-grub Save any unsaved work, leave the device plugged in and reboot for these changes to take effect. These errors can safely be ignored and should not impact the overall outcome. This had the same result as the previous lsmod.
It will help you restore system if installed driver not complete. Note: You need to access the internet on your computer to download the driver. As far as I know, that driver should already be shipped with my current kernel packages. Hi I am new to Ubuntu and Linux. Driver Easy will then scan your computer and detect any problem drivers. I'm planning to use the dongle to be a client on another network.
Part Three Now, run these two commands in an open terminal to load the driver modules at boot time. Could you help guide me to install the correct driver? Part Four Finally, the script mentions something about updating your initramfs. But with the Pro version it takes just 2 clicks and you get full support and a 30-day money back guarantee : Note: You need to access the Internet to use Driver Easy. . . . .
. . . . . .
. . . . .
. . . . .
. . . . . . .